Installation
Contents
Installation of Vortex Plus is relatively simple, because there is no need to remove the motherboard from the case. First, you need to attach two clips to the motheboard, using pegs similar to Intel stock cooler’s. In Figure 9, you can see these clips in place.
Figure 9: Clips installed on the motherboard.
Then put the cooler in place and attach it to the clip, using only one screw.
Figure 10: Coolr installed on the motherboard.
After that you need to install the fan on the cooler, as you can check in Figure 11.
In Figure 12, you can see the cooler installed in our case.
Figure 12: Installed in our case.