NZXT Switch 810 Case Review

The Front Panel (Cont’d)

At the bottom part of the front panel, the NZXT Switch 810 has a 140 mm fan, but the manufacturer doesn’t publish the specifications for this fan. This fan uses a standard three-pin fan power connector, which comes installed on a “power hub,” allowing you to feed all fans using only one peripheral power connector from the power supply. You can, of course, connect this fan directly on the motherboard, in case you want to monitor its speed.

If you want to, you can install a second 120 mm or 140 mm fan on the front panel. The case comes with an air filter for these fans.

Figure 7: Front fan

Figure 8: Air filter

The case comes with two USB 3.0 ports, four USB 2.0 ports, an SD memory card reader, and the traditional audio jacks on the top part of the front panel. The USB 3.0 ports use an internal connector, so make sure you install a motherboard with an internal USB 3.0 header. This case also has a button for turning on and off two LEDs available on the rear panel.

Figure 9: Buttons and connectors