Thermaltake Armor+ ESA Case Review
The Disk Drive Bays (Cont’d)
Contents
In front of the main hard disk drive cage there is a 120 mm fan. This fan us
es a 4-pin connector, being installed to the ESA module, allowing you to monitor and configure the fan speed through NVIDIA ESA software.
Figure 22: Front 120 mm fan.
The two bottom hard disk drive modules can be removed for the installation of additional 120- or 140 mm fans – if you are not using these modules, of course. Their removal is done by unscrewing the thumbscrews present on the bottom panel of the case.
In Figure 23, you can see the adapter for installing a floppy disk drive or an eighth hard disk drive to the case.
Figure 23: 5.25”-to-3.5” adapter.
The installation of 5.25” units is really simple. With the front doors opened, remove the cover present on the 5.25” bay you want to use, slide the 5.25” unit until you hear a click and that’s it! It couldn’t be easier. If you think your device isn’t firmly attached to the case, you can use regular screws to fasten it to Armor+.