Inside the PANZER MAX
Each panel is attached to the chassis using a quick-open mechanism operated by a lever.
The motherboard tray has a huge cutout for you to access the backplate of the CPU coolers without having to remove the motherboard from the case, and holes for you to route cables behind it. There is a 2.2 inch (55 mm) clearance between the tray and the right panel to organize the cables.
The case supports E-ATX and smaller form factor motherboards.
There is a removable cover for the power supply compartment.
Figure 12: overall look
Figure 13: a view behind the motherboard tray
In Figure 14, we have another overall look inside the case. As we mentioned before, expansion cards are held with thumbscrews.
The PANZER MAX supports video cards up to 154.4” (390 mm) long. You can install CPU coolers up to 6.7” (170 mm) tall.
Figure 14: overall look
On the front panel, there are two already mentioned 120 mm fans. There is a plastic flap that directs part of the airflow to the 2.5″ bays.
Figure 15: front sector
The power supply is installed at the bottom of the case, covered by a removable cover. It can be installed with either its bottom fan facing up or facing down, so you can decide if you want the fan of your power supply pulling air from inside the case or from outside of it. As shown before, there is an air filter for the power supply fan.
You will be able to fit power supplies up to 15” (390 mm) deep if you don’t install a fan in the bottom panel.
Figure 16: power supply compartment