In Win G7 Case Review

Inside the In Win G7

Both panels are attached to the chassis using black thumbscrews. The motherboard tray has a huge cutout for you to access the backplate of the CPU coolers without having to remove the motherboard from the case, several holes for you to route cables behind it, and several clips for you to fasten cables using cable ties. Also, the motherboard tray doesn’t go all the way to the case’s bottom panel, leaving a lot of room for you to route and/or hide the cables from the power supply.

Figure 12: Overall look

Figure 13: A view behind the motherboard tray

In Figure 14, we have another overall look inside the case. Expansion cards are fastened using regular screws (at least they are black), accessed from outside the case. The In Win G7 supports video cards up to 16” (408 mm) long.

Figure 14: Overall look

The power supply is installed at the bottom of the case. It can be installed with either its bottom fan facing up or facing down, so you can decide if you want the fan of your power supply pulling air from inside the case or from outside of it. As shown before, there is an air filter for the power supply fan.

The case supports the installation of a 92 mm or 120 mm fan on its bottom panel, and the case has an air filter for this optional fan.

On the case’s default configuration, you can install power supplies up to 11” (280 mm) deep. If you install a 92 mm fan on its bottom panel, this clearance is reduced to 7.7” (195 mm), and if you install a 120 mm fan, this clearance is reduced to 6.9” (175 mm).

Figure 15: Power supply compartment