In Win GT1 Case Review

Inside the In Win GT1

Both panels are attached to the chassis using black metallic thumbscrews. The motherboard tray has a huge cutout for you to access the backplate of the CPU coolers without having to remove the motherboard from the case, and several clips for you to fasten cables using cable ties. The motherboard tray doesn’t go all the way to the bottom panel, leaving a huge space for you to route cables behind it.

Figure 12: Overall look

Figure 13: A view behind the motherboard tray

In Figure 14, we get another overall look inside the case. Expansion cards are fastened using regular black screws, accessible from outside the case. On its default configuration, the In Win GT1 supports video cards up to 10.6” (270 mm) long. With the top hard drive cage removed, this clearance is increased to 16.1” (408 mm).

Figure 14: Overall look

The power supply is installed at the bottom of the case. It can be installed with either its bottom fan facing up or facing down, so you can decide if you want the fan of your power supply pulling air from inside the case or from outside of it. As shown before, there is an air filter for the power supply fan. On the case’s default configuration, you can install power supplies up to 10.6” (270 mm) deep.

Figure 15: Power supply compartment

The bottom panel allows the installation of an 80 mm or a 120 mm fan. If a 120 mm fan is installed, the power supply depth limit is 6.3” (160 mm), whereas with an 80 mm fan installed, this limit is 7.1” (180 mm).