In Win GT1 Case Review

The Disk Drive Bays

The In Win GT1 has three external 5.25” bays, one 3.5”/2.5” external docking bay, six internal 3.5”/2.5” bays in two cages, and one internal 2.5” bay. The installation of 5.25” and 3.5” devices can be done without the use of tools or screws, but installation of 2.5” devices require the use of regular screws.

Figure 16: Default configuration of the disk drive bays

As mentioned before, you can remove the top hard drive cage to allow the installation of video cards longer than 10.6” (270 mm). However, to remove this cage, you need only to remove its left-side wall, and the single 2.5” bay, which is located inside the top cage, will still be available. See Figure 17.

Figure 17: Top hard drive cage removed

Each 3.5”/2.5” bay is actually a small drawer that comes with rubber rings to reduce the vibration and noise produced by 3.5” hard disk drives.

Figure 18: One of the 3.5”/2.5” bays